Wham Bam Cloud Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mount for the Wham Bam Cloud that allows the use of screws.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 64
- Wydruki
- 1
- Wyświetlenia
- 434
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A mount for the Wham Bam Cloud that allows the use of two screws for mounting to the roof of an enclosure.
This should be printed in a heat resistant material. There are two versions, one has a narrower side that may be safer should the device activate. This was feedback from Wham Bam.
The mount is in two parts that are designed to be snapped together but can easily be separated by twisting.
After printing, secure the base with two countersink screws to the top of the enclosure following the recommendations for positioning of the Cloud. Place the Cloud in the ring with the foil side showing through the opening and snap the ring onto the base. Rotate the ring to align the cutouts if needed. To separate the mount just twist the ring and the mount with separate.
V1 - original design
V2 - smaller side walls as recommended by Wham Bam