1 / 8
rain/snow cover TRP Spyre Road MD-C610 disc brake (rear) — zdjęcie 1
1 / 8

rain/snow cover TRP Spyre Road MD-C610 disc brake (rear)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

rain/snow cover for TRP Spyre Road MD-C610 disc brake (rear one) to ensure that no water gets into the bowden cable.

Ocena
0 / 5
Polubienia
2
Pobrania
16
Wydruki
0
Wyświetlenia
380
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

I encountered the problem that in the months with temperatures < 0°C my rear brake bowden cable freezed because there was water in the bowden cable. unfortunately this brake is designed in a way that in horizontal mounting position (as shown in the pictures) the outlet of the bowden cable is pointing upwards. this cover is only clamped with a cable tie.

there are two variants:

  1. variant with only one part/piece (must be printed with an flexible material)
  2. variant with two pieces (only clamp must be printed with a flexible material)

i created the second variant because my TPU that i had at home was very wet and the print did not look very good.

other needed parts:

variant 1 :  

  • 1 pc. cable tie (width < 5mm)

variant 2 :

  • 1 pc. cable tie (width < 5mm)
  • 2 pc. M3x20mm (head has not to be a specific type)
  • 2 pc. M3nS nut (1,8mm thickness)

depending on the variant, the following parts must be printed with TPU or other flex material:

  • onepiece_flex_bowden_raincover_TRPSpyreRoadMD-C610_back.stl
  • two_piece_bowden_raincover_TRPSpyreRoadMD-C610_back_part2.stl

but you will never use both of them at the same time.

 

In general i recommend using materials that are resistant to UV and water.

Tagi