rain/snow cover TRP Spyre Road MD-C610 disc brake (rear)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
rain/snow cover for TRP Spyre Road MD-C610 disc brake (rear one) to ensure that no water gets into the bowden cable.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 16
- Makes
- 0
- Views
- 380
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Share Alike
I encountered the problem that in the months with temperatures < 0°C my rear brake bowden cable freezed because there was water in the bowden cable. unfortunately this brake is designed in a way that in horizontal mounting position (as shown in the pictures) the outlet of the bowden cable is pointing upwards. this cover is only clamped with a cable tie.
there are two variants:
- variant with only one part/piece (must be printed with an flexible material)
- variant with two pieces (only clamp must be printed with a flexible material)
i created the second variant because my TPU that i had at home was very wet and the print did not look very good.
other needed parts:
variant 1 :
- 1 pc. cable tie (width < 5mm)
variant 2 :
- 1 pc. cable tie (width < 5mm)
- 2 pc. M3x20mm (head has not to be a specific type)
- 2 pc. M3nS nut (1,8mm thickness)
depending on the variant, the following parts must be printed with TPU or other flex material:
- onepiece_flex_bowden_raincover_TRPSpyreRoadMD-C610_back.stl
- two_piece_bowden_raincover_TRPSpyreRoadMD-C610_back_part2.stl
but you will never use both of them at the same time.
In general i recommend using materials that are resistant to UV and water.