1 / 15
SkiDock - Magnetic Ski and Snowboard Holder for Vehicles — zdjęcie 1
1 / 15

SkiDock - Magnetic Ski and Snowboard Holder for Vehicles

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

SkiDock: Keeps skis/snowboards upright on vehicles, protecting them from ground damage. Ideal for organized ski trips.

Ocena
5 / 5
Polubienia
82
Pobrania
353
Wydruki
6
Wyświetlenia
3365
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The most up-to-date model is HERE (Makerworld)

 

Based on the “SnoStrip” but for us DIY folk, and not $50 ;)

As a passionate skier and tinkerer, I modeled the SkiDock to share with fellow enthusiasts. This project is born out of my desire to enhance the getting ready part of the ski experience. It's a straightforward design, requiring just a few magnets and some 1/2-inch rubber pads, making it incredibly easy to assemble and print. Ideal for those who enjoy hands-on projects and practical solutions for winter sports!

 

Here are the links to the magnets and Pads used:

Print Recommendations:

I am using supports and the Strength Profile, and I find that printing them on their side yields the best results. I also find it beneficial to add a brim on the Connector Piece, although I have discovered that it is not entirely necessary. In terms of keeping the magnet and the connections in place, I prefer using super glue. However, I have recently started using 3M VHB tape as an alternative method, and I have found it to be successful so far. If you choose to use glue, ensure that the magnet is free of any oils, and it may be helpful to roughen the surface of the magnet with sandpaper.

 

Version 3 Update 1/7/23: Note: Not all the photos are reflective of these modifications.

  • Added middle spacers to decrease the likelihood of scratches on the vehicle. 
  • Added depth (4mm total) for magnet hole. This allows for double-sided adhesive to secure magnets in place, as opposed to superglue (I recommend the 3M VHB Tape)
  • Modified the design to have a wider slot between risers for wider skis. This will still work with smaller skis but is more reliable for all sizes. 

Print Settings

Printer Brand:

Any

Printer: 

Any SLS or FDM

Rafts:

Doesn't Matter

Supports: 

Yes

Resolution:

0.2

Infill: 

25%

Filament: Any PLA Any

Notes:

You could use any type of filament. 

 

Category: Sport & Outdoors

Tagi