1 / 3
Victoreen CDV-700 probe handle
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Handle and a holding clip for probe with 90 degrees of articulation.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 150
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (12)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (1)Powiązane
I observed that the probe was pretty slippery if you wanted to hold it by pinching while getting it level on a surface or near something on surface. Wanted to make some kind of extra handle to improve user experience and adding a possibility to add some kind of extension adapter if wanting to measure radiation near ground and not needing to bend over all the time.
- Hole which joins handle to the clip is 4,25mm in diameter in CAD, so M4 bolt should do it.
- Handle had M10x25 thread on the end of it if extension is wanted.
- Handle's M10 thread has been modified for more clearance. Both thread faces are pulled by -0,2mm and the thread's level face by -0,1mm
- I didn't dare to test flexibility of the clip which I printed out from PETG, so I just slid the probe into the clip from the end.
- Clip lock is just a friction fit clamp which squeezes the clip more shut. Clip lock is pushed on from the end. In my experience it is enough.
- I used fuzzy skin on the handle and modifiers for infill. 15% for the handle wide part and 70% for the handle's connecting part.
EDIT: I also added M30 threaded version of the handle if M8 feels too brittle