Milwaukee Packout Compatible Organizer - 4 Cavity Divided Rectangular Bin

After duplicating the Milwaukee Packout Low-Profile Organizer bins, and creating dividers and a modified low-profile square bin that can go where the low-profile rectangular bin normally sat, I decided I might as well duplicate the deep bin as well.

So, I first duplicated the Milwaukee Packout Organizer Square bin. Then, got busy with work and didn't get a chance to work on the rectangular bin - until now.

Then, just the other day, I created the Milwaukee Packout Organizer Rectangular Bin that is a duplicate of the original.  After posting that one, I was messaged, and asked to make it divided, but with removable dividers like the low-profile ones.  So I did.

So, here is a Milwaukee Packout Organizer compatible rectangular bin that is functionally equivalent to the original, but with removable dividers! I have printed it in PLA and PETG. The PLA is more rigid, and easier to remove the organic supports - they just pop right off. The PETG is a bit more flexible, and I think will handle drops better, but the organic supports like to stick more, and I have to use a dental pick to get them out from under the lip. But it is worth it to print them in PETG in my opinion.

I print three of the dividers at a time using organic supports.  I print them vertically, since they look the best when printed that way.  I tried printing them on their side, but they look terrible.  Make sure you have really good bed adhesion, or use a brim, otherwise the ends will lift and you will have issues with fitment.