KINGSONG S18 SUSPENSION SEAL HOLDERS
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These two little pieces are designed to keep the seals in place on the kingsong S18 suspension rails.
- Ocena
- 3 / 5
- Polubienia
- 9
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 387
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Visit my Cults3D page for more designs
There are two different files, one for the right side of the wheel and another one for the left side, where the cable cover is. No need to take the cable cover off.
You will need 4x m3x12 bolts
How to attach : Remove the original phillips screws, slide in place the holders and attach with the new m3x12 bolts. Note that you will need to use a bit of force to slide the holders in place but they will not break if printed properly.
Here are the main settings I use to print the pads with PETG
- 4 bottoms
- 6 tops
- 3 perimeters
- 15% infill
- Supports : Yes for the underside of the screw mounts