Kobalt hex key set for Honeycomb Storage Wall (HSW)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed for a Kobalt hex key set (may fit similar brands). CAD model available.
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 80
- Wydruki
- 0
- Wyświetlenia
- 523
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model snugly holds a single Kobalt hex set on a honeycomb storage wall (HSW). Instead of using the classic screw or hex-based insert, this model uses a clip on design from KXY Design. (If you haven't already, check out their EZ clips!)
This works with a Kobalt hex set that contains a star, metric, and imperial (SAE) keys. Note that the diameter of the largest metric size means that the metric key set can only be inserted in a single direction. The other 2 can be inserted either way down.
Note that the model in the picture uses 3 hooks (v3), which I've since determined is an overkill so the model I've uploaded includes just 2 on the ends. I found the fit was just too tight with 3, but haven't re-printed since I only have one set of these ;-)
Because I'm using the KXY hooks, I strongly suggest printing the hooks for maximum strength. which means printing this model on it's side. (Slicer example shown below.). Unfortunately, this means enabling supports. Boo! I know, I know. I hate them too. PrusaSlicer's organic supports make this a bit less painful…
I printed mine in some super cheap PETG with a 0.6mm nozzle, but do whatever works for you.
Apologies to anyone who opens the CAD files; not my best work, but hopefully it helps someone out if you just need to make some small changes.