1 / 1
Lifetime Teton Pro Kayak Rod Holder Rotate 45° Bracket — zdjęcie 1

Lifetime Teton Pro Kayak Rod Holder Rotate 45° Bracket

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Created this bracket to rotate the rod holders on my Teton pro so the rods don't stick out of the kayak

Ocena
0 / 5
Polubienia
10
Pobrania
97
Wydruki
0
Wyświetlenia
942
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

I created this bracket for my Lifetime Teton Pro's rod holders after getting the idea from a fellow kayak owner on a FB group. This is meant to reorient your rods so that they are inline with the kayak rather than sticking out perpendicular to the kayak. This was a real issue when going through low lying branches and having my rods snag. 

This design is a work in progress and I'm also fiddling around with different angles and potentially seeing if I can get the rod holders to tilt downward too. 

Holes are sized for M3 hardware. I would also highly recommend to use marine grade silicone to make sure there aren't any areas where water can ingress into your kayak. This is quite a large opening into the hull and can affect buoyancy and potentially cause your kayak to sink.

 

I printed this with ASA for its UV resistance with no cooling and supports on. Enclosure, slow speeds, and PEI textured plate for best results. I would recommend to split the file to print one bracket at a time since there might be a likelihood for ASA to fail to adhere. I personally had quite a few failures since I was printing on an Ankermake M5C before I had my enclosed Bambu. This will save you material in the case of a print failure.

 

Please let me know if you have any questions or comments. Thanks for checking out!