Lifetime Teton Pro Kayak Rod Holder Rotate 45° Bracket
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Created this bracket to rotate the rod holders on my Teton pro so the rods don't stick out of the kayak
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 97
- Makes
- 0
- Views
- 940
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution
I created this bracket for my Lifetime Teton Pro's rod holders after getting the idea from a fellow kayak owner on a FB group. This is meant to reorient your rods so that they are inline with the kayak rather than sticking out perpendicular to the kayak. This was a real issue when going through low lying branches and having my rods snag.
This design is a work in progress and I'm also fiddling around with different angles and potentially seeing if I can get the rod holders to tilt downward too.
Holes are sized for M3 hardware. I would also highly recommend to use marine grade silicone to make sure there aren't any areas where water can ingress into your kayak. This is quite a large opening into the hull and can affect buoyancy and potentially cause your kayak to sink.
I printed this with ASA for its UV resistance with no cooling and supports on. Enclosure, slow speeds, and PEI textured plate for best results. I would recommend to split the file to print one bracket at a time since there might be a likelihood for ASA to fail to adhere. I personally had quite a few failures since I was printing on an Ankermake M5C before I had my enclosed Bambu. This will save you material in the case of a print failure.
Please let me know if you have any questions or comments. Thanks for checking out!