Procrastination RC car
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I was bored so I taught my plane to drive
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 1389
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
The weekend before midterms I was sitting around avoiding studying when I saw an rc plane in the corner and I decided to teach it to drive, this is the result.
Parts list:
Front Wheels https://store.flitetest.com/2-75-wheel-pair-v-2/
Electronics https://store.flitetest.com/ft-power-pack-c-radial-v-2/
Use any rc plane reciever of your choice
Use any 1300mah 3s lipo you can find
m3 screws
Assembly:
The steering hinges are assembled with m3 screws and the servo is screwed in with self tapping screws and is connected with a pushrod as you can see here.
The main chassis can be attached to the steering hinges by using bolts that pass through the back (non moving) part of the steering assembly and the mounting plate and also the chasiss.
The motor is attached with m3 screws and the small gear is attached with the included bolt from the electronics kit.
The axle is secured in place with either a lynch pin or fillament that is melted with a soldering iron to the axle.
The bigger gear is attached to the axle by using a soldering iron to melt it in place and same thing with the wheel hubs or entire wheels if you dont have a tpu compatable printer.
The electronics can just be hot glued or zip tied to the top and bottom, I put the esc on the bottom and the reciever on top.