Bitaxe Ultra 1366 Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Printable case for the Bitaxe Ultra 1366 Solo/Lottery Miner
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 125
- Wydruki
- 0
- Wyświetlenia
- 1976
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This case is for the Bitaxe Ultra 1366 Bitcoin solo/lottery miner. There are two different versions of the bottom part - one with and the other without mounting holes. All parts can be printed without support.
The design requires the use of threaded/heat set inserts and an extension cable for the display.
BOM:
- 4x M3 threaded inserts (M3x5.7)
- 4x M3x10 round head screw
- 1x 4-pin extension cable (length max. 10cm, so you can easily work during assembly)
The display is slided in from one side and is held by that bridge. It's a snug fit but after you managed to get it in, that boy ain't going nowhere ;)
As the temperatures of the Bitaxe Ultra 1366 normally don't exceed 55°C, I printed the lid with PLA+ and the bottom with ABS+. In hindsight, that wasn't that clever as the materials have different shrinkage factors. So I recommend simply using the same material and one that can handle the temperatures.