1 / 5
XL Filament Sensor Blocks (3x and 6x) with PC4-M10 Passthrough Fittings — zdjęcie 1
1 / 5

XL Filament Sensor Blocks (3x and 6x) with PC4-M10 Passthrough Fittings

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a modified version of the official XL Filament Sensor blocks that were reworked to accept a PC4-M10 fitting.

Ocena
5 / 5
Polubienia
87
Pobrania
358
Wydruki
16
Wyświetlenia
2962
Oceny
14

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v2.0

This is a modified version of the official XL Filament Sensor blocks that were reworked to accept a PC4-M10 fitting. I have also provided a 2x filament sensor block.

I made this mod because I was tired of the PTFE tubes popping out the back of the official sensor blocks.

I used these PC4-M10 fittings off Amazon, chosen because of their thread depth, beveled edges, and collet thickness. You can fit the whole fitting inside a 10mm socket.

https://www.amazon.com/gp/product/B086W9HZDK

I used this 10mm socket to install the fittings. It has just the right amount of thickness to allow it to tighten an inner fitting.

https://www.amazon.com/gp/product/B09BTNVVVW

I finished off the design with some collet clips to make sure the PTFE tubes would stay in place.

https://www.amazon.com/gp/product/B0BCJ4JCCR

 

Tagi