XL Filament Sensor Blocks (3x and 6x) with PC4-M10 Passthrough Fittings
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a modified version of the official XL Filament Sensor blocks that were reworked to accept a PC4-M10 fitting.
- Rating
- 5 / 5
- Likes
- 87
- Downloads
- 360
- Makes
- 16
- Views
- 2,982
- Reviews
- 14
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- GNU General Public License v2.0
This is a modified version of the official XL Filament Sensor blocks that were reworked to accept a PC4-M10 fitting. I have also provided a 2x filament sensor block.
I made this mod because I was tired of the PTFE tubes popping out the back of the official sensor blocks.
I used these PC4-M10 fittings off Amazon, chosen because of their thread depth, beveled edges, and collet thickness. You can fit the whole fitting inside a 10mm socket.
https://www.amazon.com/gp/product/B086W9HZDK
I used this 10mm socket to install the fittings. It has just the right amount of thickness to allow it to tighten an inner fitting.
https://www.amazon.com/gp/product/B09BTNVVVW
I finished off the design with some collet clips to make sure the PTFE tubes would stay in place.
https://www.amazon.com/gp/product/B0BCJ4JCCR