KNIPEX PWS PLUS 2mm Mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mod allows PWS Plus stripper to remove 2mm of insulation instead of (4 mm stock) great for small JST connectors
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 348
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This modification allows a KNIPEX PWS-Plus to strip a minimum of 2mm of insulation. Stock it can only remove 4mm. I created this modification while crimping a JST PH 2.0mm pitch connectors. This makes the job very easy and everything is a nice consistent length.
There are two models of this striper (26-36 and 18-28 AWG). I believe they all use common parts and just have a different limit block. I use my 26-36 model on 20 to 24 AWG wires frequently. Cut the insulation and then let up on the pressure and you will get a nice clean strip with no snagged or nicked wires.
The Jokari version has a min strip length of 1.5mm and has a very similar stop block to my modification
https://jokari.de/en/PWSPLUS-003-2.htm
Build Tips:
1) Any filament will do. I used ABS
2) A sharp pic tool is recommend to remove the stock backing plate shown in the pictures.
3) The model is slightly over sized. Set you seam to the rear and use a file with a few strokes at a time to adjust the fit to your liking. The *.F3D model is available to edit if you wish
4) Re use the stock backing plate. If you need to drill the holes a 1/16 (0.063in) drill bit will clean the hole to the correct size.
5) Pay attention to inserting the wire straight especially with silicon insulation. It is easy to get it crooked.