KNIPEX PWS PLUS 2mm Mod
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mod allows PWS Plus stripper to remove 2mm of insulation instead of (4 mm stock) great for small JST connectors
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 16
- Makes
- 0
- Views
- 348
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution
This modification allows a KNIPEX PWS-Plus to strip a minimum of 2mm of insulation. Stock it can only remove 4mm. I created this modification while crimping a JST PH 2.0mm pitch connectors. This makes the job very easy and everything is a nice consistent length.
There are two models of this striper (26-36 and 18-28 AWG). I believe they all use common parts and just have a different limit block. I use my 26-36 model on 20 to 24 AWG wires frequently. Cut the insulation and then let up on the pressure and you will get a nice clean strip with no snagged or nicked wires.
The Jokari version has a min strip length of 1.5mm and has a very similar stop block to my modification
https://jokari.de/en/PWSPLUS-003-2.htm
Build Tips:
1) Any filament will do. I used ABS
2) A sharp pic tool is recommend to remove the stock backing plate shown in the pictures.
3) The model is slightly over sized. Set you seam to the rear and use a file with a few strokes at a time to adjust the fit to your liking. The *.F3D model is available to edit if you wish
4) Re use the stock backing plate. If you need to drill the holes a 1/16 (0.063in) drill bit will clean the hole to the correct size.
5) Pay attention to inserting the wire straight especially with silicon insulation. It is easy to get it crooked.