1 / 4
Magsafe Dome Charging Stand
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Charging stand for most standard wireless magsafe Apple chargers
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 68
- Wydruki
- 0
- Wyświetlenia
- 522
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (14)Powiązane
Description
Magsafe charging stand with a unique dome-like design. Works as a desk accessory at the office/home or on a bedside table. Easy to print design.
Usage
- Press fit your magsafe charger (56mm diameter) into the slot at the top.
- Feed the end of the wire through the entry port at the back of the stand.
- Roll up any excess wire as needed inside the stand.
- Press the remaining wire into the hole at the base of the stand.
- Additionally, you may use some double sided tape on the base for permanent use.
Print Settings
- Minimum 3 walls for rigidity though you might get away with 2 (2 untested).
- As there are no flat top layers, realistically you could use 0% infill as the stand should be under no unnecessary stress (though I printed with 10% infill). I have tested with 0% infill and it printed with no issues and still strong enough for normal use.
- Ensure you have good bridging settings for the cable entry port at the back of the stand.
- For best visual results, ensure the Z-seam is configured to the rear of the stand.