1 / 2
Dual Filament Voron M4 Extruder + Creality mount — zdjęcie 1
1 / 2

Dual Filament Voron M4 Extruder + Creality mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mod to allow two filament paths to the Voron M4 Extruder. Optional Mount for Creality printers see F3d File for Variants

Ocena
5 / 5
Polubienia
23
Pobrania
61
Wydruki
1
Wyświetlenia
1257
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This modification for the Voron M4 extruder allows for two separate filament paths. 

https://vorondesign.com/voron_m4

I use the top for internal chamber mounting and the bottom for and external 3D Chameleon MMU. Or what ever external source you choose.

To retain as many stock parts as possible the filament inlets have been shifted over to make room for the E-Sun push to connect fittings. This required a 3D path for PTFE tube to extend through the Y junction. 

Use the splitter tool and a box cutter to cut each tube separately. When assembled they will self align.  

(Creality Install)

Remove the stock extruder motor. Tap the existing clearance holes with a M4 Tap. The Tap drill size for an M4 is 3.3mm. The factory holes were close enough to not need drilling. Secure with M4x10mm screws. 

An extended motor cable is needed for this mount. 

 ~10 cm in length 

 24 AWG wire 

Connectors 

4 Pin JST XH

6 Pin JST PH 2.0

!!! The stock connectors have a heavy coating of hot glue. Warm everything up with a heat gun before removing. I had one that looked like there was no glue but it had dripped down inside the connector. After the heat gun no issues!!!!

Recommended Crimp Tool + Stripper

Engineer Precision Crimping Pliers for Open Barrel Terminals PA-09

https://a.co/d/1O4KAIb

 

Make yourself a pin loader tool (Far less Fumbling) see video below.

 

Knipex PWS Plus (4mm Min Strip) 

https://a.co/d/9OJVg59 

 Modified Knipex stop (2mm Min Strip)

 https://www.printables.com/model/700358-  knipex-pws-plus-2mm-mod

 

Jokari PWS-Plus (1.5mm Min Strip) 

!!!No mod needed!!!

https://a.co/d/g14OnJr

 

Taping the mounting holes in tight quarters is much easier with Tap Socket. Buy the set and add it to you tool box. You will be happy you did!

https://a.co/d/eCBno8a

 

 

 

 

There are three variants. See the Fusion (*.F3D file) for reference.  Pictured below is the M4 mounted on a Crealtiy Cr6-Se.

  1. Creality Mount with Dual Filament
  2. Creality mount for Single Filament
  3.  Flat Mount for Dual Filament

Tagi