Battery cover replacement for this random Fisher Price jumper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement battery cover for a Fisher Price jumper, may fit others but I can't confirm. Ignore the mess, baby did it.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 216
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
A very kind neighbor gave us a old jumper they no longer used but it was missing the battery cover, as much as I enjoy chewing on some AAs I didn't want my baby doing it.
A couple of quick measurements and a few iterations later I had a cover that fit close enough to work.
Its a pretty simple model, printed in standard PLA with defaults for Fine Quality in Elegoos version of Cura with the exception of lowering the infill to 10% and bumped the speed up to 500mm/s, it took about 13 minutes.
You will want to wait for a few after the print is done before removing as the shape makes it prone to warping if removed while still warm.
For the screws honestly idk, I dug around in my cabinet of random screws until I found two that were close enough to go in.