Battery cover replacement for this random Fisher Price jumper
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A replacement battery cover for a Fisher Price jumper, may fit others but I can't confirm. Ignore the mess, baby did it.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 18
- Makes
- 0
- Views
- 216
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Share Alike
A very kind neighbor gave us a old jumper they no longer used but it was missing the battery cover, as much as I enjoy chewing on some AAs I didn't want my baby doing it.
A couple of quick measurements and a few iterations later I had a cover that fit close enough to work.
Its a pretty simple model, printed in standard PLA with defaults for Fine Quality in Elegoos version of Cura with the exception of lowering the infill to 10% and bumped the speed up to 500mm/s, it took about 13 minutes.
You will want to wait for a few after the print is done before removing as the shape makes it prone to warping if removed while still warm.
For the screws honestly idk, I dug around in my cabinet of random screws until I found two that were close enough to go in.