Drill Drum Sander
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Drum sanding attachement for your power drill
- Ocena
- 0 / 5
- Polubienia
- 67
- Pobrania
- 322
- Wydruki
- 1
- Wyświetlenia
- 1982
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Drum sanding attachment for your powerdrill.
External Hardware:
- 2x 608 Bearing
- 1x M8 nut
- 1x M8 threaded Rod (90mm + Drumheight)
Print Settings:
0,2mm Layerheight, 4 perimeter, 20% Infill
Assembly:
 Add 608 Bearing to the upperside of the handle (press fit) |
 Ad 608 Bearing to the inside of the handle (press fit) |
 Add M8 threaded rod to the drum. If it's too tight by hand use your powerdrill to thread it in. The rod should be 90mm + drum height in total length. If it's too loose or get loose during work, secure it with a little bit of superglue. |
 Put the drumassembly into the handle. Make sure the side with the small circular extend faces the bearing. |
 Add the M8 nut and tighten it. Now you can also put on the cap for the handle |
 Add the sandpaper |
 Lock the sandpaper into place by rotating the locking mechanism about 90° with an 6mm allen key. When the locking mechanism is not loose in the first place, by rotating it with the allen key it should get loose. |