Drill Drum Sander
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Drum sanding attachement for your power drill
- Rating
- 0 / 5
- Likes
- 67
- Downloads
- 322
- Makes
- 1
- Views
- 1,982
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
Drum sanding attachment for your powerdrill.
External Hardware:
- 2x 608 Bearing
- 1x M8 nut
- 1x M8 threaded Rod (90mm + Drumheight)
Print Settings:
0,2mm Layerheight, 4 perimeter, 20% Infill
Assembly:
 Add 608 Bearing to the upperside of the handle (press fit) |
 Ad 608 Bearing to the inside of the handle (press fit) |
 Add M8 threaded rod to the drum. If it's too tight by hand use your powerdrill to thread it in. The rod should be 90mm + drum height in total length. If it's too loose or get loose during work, secure it with a little bit of superglue. |
 Put the drumassembly into the handle. Make sure the side with the small circular extend faces the bearing. |
 Add the M8 nut and tighten it. Now you can also put on the cap for the handle |
 Add the sandpaper |
 Lock the sandpaper into place by rotating the locking mechanism about 90° with an 6mm allen key. When the locking mechanism is not loose in the first place, by rotating it with the allen key it should get loose. |