1st Gen 4runner Rear glass regulator piece
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small plastic piece associated with the rear glass regulator locking mechanism
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 485
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
While installing a new regulator a small plastic piece associated with the rear glass regulator locking mechanism broke. A replacement part could not be sourced and being one piece would be impossible to install without destructive disassembly of the regulator. I designed a replacement part that can be installed with zero disassembly.
Print Instructions:
I used 100% infill on filamentums CPE with a brim and supports set to ‘everywhere’
I think ASA or PC would work for this application but may require some tweaking to print well.
The small screw used is a M2.5 x 0.45 mm Thread, 18 mm Long screw (McMaster-Carr # 91290A053)
No idea how long this part will last. Install at your own risk!