Needed something to mend where I had to cut a 2-inch whole house vacuum system pipe.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed something to mend where I had to cut a 2-inch whole-house vacuum system pipe to clear a clog.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 140
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
I tried sucking up shredded paper with our whole-house vacuum, only to have it clog somewhere along the pipe. I tried getting to the clog from the port in the house with a drain snake, but could not reach it. So I decided to cut the pipe in the basement to get to the clog with the snake but needed some way to easily patch the cut and still leave it if I later needed to clear another clog. This patch clamps over the two sides of the cut, sealing the pipe again.
I printed it on my MK3S using a 0.4mm nozzle, 0.3mm layer height, and black VoxelPLA. Hardware consists of:
2 - 18mm M3 screws
2- m3 hex nuts
I designed sockets for nuts on both sides of the holes because the head of the screw fits in nicely. As usual, I have included the FreeCAD file if you need to make modifications.