Needed something to mend where I had to cut a 2-inch whole house vacuum system pipe.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I needed something to mend where I had to cut a 2-inch whole-house vacuum system pipe to clear a clog.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 14
- Makes
- 0
- Views
- 140
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Share Alike
I tried sucking up shredded paper with our whole-house vacuum, only to have it clog somewhere along the pipe. I tried getting to the clog from the port in the house with a drain snake, but could not reach it. So I decided to cut the pipe in the basement to get to the clog with the snake but needed some way to easily patch the cut and still leave it if I later needed to clear another clog. This patch clamps over the two sides of the cut, sealing the pipe again.
I printed it on my MK3S using a 0.4mm nozzle, 0.3mm layer height, and black VoxelPLA. Hardware consists of:
2 - 18mm M3 screws
2- m3 hex nuts
I designed sockets for nuts on both sides of the holes because the head of the screw fits in nicely. As usual, I have included the FreeCAD file if you need to make modifications.