Hyperdeck

This hyperpixel cyberdeck uses a few parts I had sitting around. There are a few components to this, along with a couple custom PCBs for usb cable minification. All usb is 2.0 on this build. The power / battery pisugar board has been HEAVILY modified to keep the build as slim as possible.  I removed the included pisugar battery, soldered a jst connector + dupont silicon wires to the required pads for an external momentary button to use as a power switch.

• 2000mah lipo battery
• Momentary power button
• 4 port retrocution usb hub
• blackberry keyboard
• hyperpixel 3.5" screen (800x480)
• Pisugar 3
• usb 2.0 female breakout board
• male micro usb breakout board
• m2 8mm countersunk screws *8
• m2 10mm female standoffs *4
• m2.5 12mm countersunk screws *4

You may need custom pcbs for the male and female usb-c breakouts. If needed, those can be printed by pcbway or jlcpcb.

You'd probably need to redesign the top half if you want something that will work with the hyperpixel 4 or hyperpixel 4 square. I glued some ~4mm hex standoffs under the pi zero so screws would go all the way through, and keep the pisugar pressed on top of the gpio pins.

Note: if you have a hyperpixel 3.5 and try to assemble this, keep in mind that the screen driver is not supported by any version of debian higher than buster.