Hyperdeck
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple brick shell for pi zero 2 w, tindie keyboard, pimoroni screen, pisugar.
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 44
- Makes
- 0
- Views
- 1,389
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
This hyperpixel cyberdeck uses a few parts I had sitting around. There are a few components to this, along with a couple custom PCBs for usb cable minification. All usb is 2.0 on this build. The power / battery pisugar board has been HEAVILY modified to keep the build as slim as possible. I removed the included pisugar battery, soldered a jst connector + dupont silicon wires to the required pads for an external momentary button to use as a power switch.
- 2000mah lipo battery
- Momentary power button
- 4 port retrocution usb hub
- blackberry keyboard
- hyperpixel 3.5" screen (800x480)
- Pisugar 3
- usb 2.0 female breakout board
- male micro usb breakout board
- m2 8mm countersunk screws *8
- m2 10mm female standoffs *4
- m2.5 12mm countersunk screws *4
You may need custom pcbs for the male and female usb-c breakouts. If needed, those can be printed by pcbway or jlcpcb.
You'd probably need to redesign the top half if you want something that will work with the hyperpixel 4 or hyperpixel 4 square. I glued some ~4mm hex standoffs under the pi zero so screws would go all the way through, and keep the pisugar pressed on top of the gpio pins.
Note: if you have a hyperpixel 3.5 and try to assemble this, keep in mind that the screen driver is not supported by any version of debian higher than buster.