1 / 6
ratgdo 2.5i Enclosure with Wago 221 Lever-Nuts & M3 Self Tapping Support — zdjęcie 1
1 / 6

ratgdo 2.5i Enclosure with Wago 221 Lever-Nuts & M3 Self Tapping Support

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of the original ratgdo PCB Case along with the Wago bracket remix but for the self-tapping M3 screw case.

Ocena
0 / 5
Polubienia
8
Pobrania
65
Wydruki
0
Wyświetlenia
803
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a remix of the original ratgdo PCB Case from @samwiseg0 along with the awesome remix from @PatrickONeal_471773 that added support for Wago connectors to improve wiring support – Wago connectors will change your life!

The original Wago integrated version noted that it was only for the case that used screw inserts (melting) and did not contain a version to support self-tapping M3 screws which is provided by the original PCB case version.

Notes:

  • Printed, Composited, & Exported with Cura v5.4.0
  • The Wago holders are a very tight fit and takes some force to insert, but once they are installed all clips open without any issues.


Print Settings (Same as Original PCB Version):

  • 4 Perimeters/walls
  • 5 top and bottom layers
  • 25% Gyrioid Infill
  • 0.4mm line width
  • Parts are pre oriented in the correct position for printing
  • No supports!