Audi B6 Vent Pod 52mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a pod for the boost gauge in my 2005 Audi A4 B6. I couldn't find anything created for this car to mount a gauge…
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 188
- Wydruki
- 1
- Wyświetlenia
- 791
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
This is pod for the boost gauge in my 2005 Audi A4 B6. I couldn't find anything created for this car to mount a gauge and I didn't want to buy the replacement vent with the gauge in the centre. To install the vacuum line and power to the pod, I drilled a 1/4" hole through the air duct to feed the lines up through.
I had to wrap my actual gauge with a couple layers of tape for it sit snug.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.15mm
Infill:
15%
Filament: FlashForge PETG Natural
Notes:
I printed this in PETG but PLA or anything would work fine.
Category: Automotive