IKEA Malm Cabinet Drawer Insert / Komode Schublade Organizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Various inserts for IKEA Malm cabinet drawers (not desk drawers)
- Ocena
- 5 / 5
- Polubienia
- 141
- Pobrania
- 673
- Wydruki
- 5
- Wyświetlenia
- 3495
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
About the model
IKEA Malm drawers are around 70x42 cm. The drawer has been devided into a 6x6 cm grid leading to a total of 12x7 elements.
Because of the square grid each insert can be rotated as needed.
Elements are provided from 1x1 (6x6 cm) up to 4x4 (24x24 cm).
The model was inspired by this one but optimized for standard (living room) Malm cabinets instead of the Malm desk.
How to print
My prefered settings to get sturdy but lightweight prints here are:
- PLA
- 0.4 mm nozzle
- around 0.4 mm line width
- 0.2 mm layer height
- only one wall line
- 3 top shell layers
- 1 bottom shell layer
- 5% 3D honeycomb infill
- Ironing the top most surface
This will result in walls with two outlines and a little bit of infill in between which is fine even for the big 24x24 cm inlay. The bottom will consist of 4 layers without infill.
The result is only 19 g for the 1x1 inlay.
Please let me know if you find a better tradeoff between sturdiness and weight.
Very well suited to get rid of all your filament rests :)