1 / 5
Ergonomic thumb pick for guitar, banjo, Dobro/resonator and steel guitar (easy to print) — zdjęcie 1
1 / 5

Ergonomic thumb pick for guitar, banjo, Dobro/resonator and steel guitar (easy to print)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The picks that I found in the local music stores were unconfortable for me so I decided to plan my own ergonomic design.

Ocena
4,75 / 5
Polubienia
79
Pobrania
594
Wydruki
8
Wyświetlenia
1495
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Music
Licencja
Creative Commons — Attribution — Noncommercial

The picks that I found in the local music stores were unconfortable for me so I decided to plan my own ergonomic design. I optimized it for 3d printers

 

-printing position is important for a good result. After you place it to the slicer do not rotate vertically. Anyway very easy and fast to print, but brim is very important, i could not print without brim

 

-material: PETG/PLA

-layer height: 0.1mm

-brim: min. 3-4 line count

-infill: no matter

-support: no

 

-The original model is an L sized pick

-If it's too tight or too loose for you put it carefully into hot water for a couple of seconds, or use a hairdryer to heat it up a little bit and change a shape. Or you can set the size 5-10% larger or smaller in your slicer. It's about your finger size

-After the print is necessary to sand the edges with fine sandpaper, and you can sand the tip of the pick a bit for softer picking sound.

 

Tagi