1 / 5
Ergonomic thumb pick for guitar, banjo, Dobro/resonator and steel guitar (easy to print) — image 1
1 / 5

Ergonomic thumb pick for guitar, banjo, Dobro/resonator and steel guitar (easy to print)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

The picks that I found in the local music stores were unconfortable for me so I decided to plan my own ergonomic design.

Rating
4.75 / 5
Likes
79
Downloads
594
Makes
8
Views
1,495
Reviews
4

Updated at source:

Model information

Category
Music
License
Creative Commons — Attribution — Noncommercial

The picks that I found in the local music stores were unconfortable for me so I decided to plan my own ergonomic design. I optimized it for 3d printers

 

-printing position is important for a good result. After you place it to the slicer do not rotate vertically. Anyway very easy and fast to print, but brim is very important, i could not print without brim

 

-material: PETG/PLA

-layer height: 0.1mm

-brim: min. 3-4 line count

-infill: no matter

-support: no

 

-The original model is an L sized pick

-If it's too tight or too loose for you put it carefully into hot water for a couple of seconds, or use a hairdryer to heat it up a little bit and change a shape. Or you can set the size 5-10% larger or smaller in your slicer. It's about your finger size

-After the print is necessary to sand the edges with fine sandpaper, and you can sand the tip of the pick a bit for softer picking sound.

 

Tags