1 / 3
Strain Relief Voron V0.2 Umbilical Dragon Burner w/Orbiter
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A bracket to provide cable strain relief when using the Dragon Burner toolhead and Orbiter v2 Extruder
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 82
- Wydruki
- 0
- Wyświetlenia
- 1550
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (22)Powiązane
I made this small bracket to provide some strain relief for the umbilical on my Voron V0.2.
It fits the Dragon Burner toolhead by chirpy2605 with an LDO Orbiter extruder.
I think I was lazy when routing my V0's cabling - I didn't really follow the guide. I ended up routing my cables near the cabling of the Orbiter extruder's motor. These cables probably need some strain relief so this simple bracket attempts to do that.
- Use 2x M3x8 bolts to attach to the toolhead board mounts (I'm not using one).
- Check that the bolt heads clear the A/B motor drive units when at Y0. You might need bolts with small heads (mine just miss the motor drives!).
- Loop a small cable tie through the hole to secure your cabling.
