1 / 2
Dell USB-C Dock Port Saver (WD15 + Latitude 7390/7490) — zdjęcie 1
1 / 2

Dell USB-C Dock Port Saver (WD15 + Latitude 7390/7490)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Smaller version of usb-c dock port saver by @bkgoodman_108348

Ocena
5 / 5
Polubienia
22
Pobrania
257
Wydruki
1
Wyświetlenia
1116
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial

At first I just wanted to change the height of the original model to fit my Latitude 7490.

After printing small slice of model to test fit, I realized that's all you need. It prints below 10min and uses ~30cm of filament. 

Tested with Latitude 7390/7490 and Vostro 5471. Since it slides deeper on the connector, it should also be compatible with computers that have a usb port located a little higher or lower.

Print instructions

I recommend at at least 3 perimeters, infill shouldn't matter then. You can go all the way up to 100% - filament usage stays almost the same. 

Fit instructions

You should slide it so that the top side of the printout is looking towards computer. If you're not sure, try both ways - correct is when it slides deeper onto connector.

Tagi