1 / 2
Dell USB-C Dock Port Saver (WD15 + Latitude 7390/7490) — image 1
1 / 2

Dell USB-C Dock Port Saver (WD15 + Latitude 7390/7490)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Smaller version of usb-c dock port saver by @bkgoodman_108348

Rating
5 / 5
Likes
22
Downloads
257
Makes
1
Views
1,116
Reviews
1

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial

At first I just wanted to change the height of the original model to fit my Latitude 7490.

After printing small slice of model to test fit, I realized that's all you need. It prints below 10min and uses ~30cm of filament. 

Tested with Latitude 7390/7490 and Vostro 5471. Since it slides deeper on the connector, it should also be compatible with computers that have a usb port located a little higher or lower.

Print instructions

I recommend at at least 3 perimeters, infill shouldn't matter then. You can go all the way up to 100% - filament usage stays almost the same. 

Fit instructions

You should slide it so that the top side of the printout is looking towards computer. If you're not sure, try both ways - correct is when it slides deeper onto connector.

Tags