1 / 4
Top-mounted filament thru-port for Prusa Lack Enclosure V2. — zdjęcie 1
1 / 4

Top-mounted filament thru-port for Prusa Lack Enclosure V2.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A filament thru-port for the top of your Prusa Lack Enclosure V2.

Ocena
5 / 5
Polubienia
2
Pobrania
58
Wydruki
1
Wyświetlenia
364
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

There are many filament thru-ports for the classic Lack 3d printer enclosure, but this one is mine. 

When I built my Lack enclosure, I cut up the top of my enclosure to make space for the MMU2, but never actually installed the MMU2.  Because of this, I just need my filament port to go through the thin top layer of the table top.  That's what my design does.  

This design supports 1.75mm filament, and you'll need a short length of PTFE tubing to complete the design.  Cut a 22mm length of PTFE tubing and insert it firmly but carefully so that about 1mm sticks out on either end.  I have found this minimizes friction and noise.

Design notes
  • This filament port is designed to go through a 1/4" hole, which was as small as I could get it to work. This does mean the bolt is somewhat delicate, so do *not* overtighten as this will almost certainly snap the bolt portion off.
  • Tolerances are very small, so I recommend using a 0.4mm nozzle with 0.1mm layer height. I recommend printing at a relatively slow speed.
  • If you heat your enclosure, make sure the parts are printed in a material that will hold up to the temperatures.  Since this part will be located at the very top of the enclosure, it is subject to the highest temperatures.
  • If this doesn't fit your brand of PTFE tubing, try scaling up or down in 1% increments.
  • The port may seem to be longer than necessary at first glance.  I found that the friction provided by a long bolt grips the PTFE tube well enough that it will stay in place without any additional glue.

Good luck, and I'd love to see your prints!

Tagi