Top-mounted filament thru-port for Prusa Lack Enclosure V2.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A filament thru-port for the top of your Prusa Lack Enclosure V2.
- Rating
- 5 / 5
- Likes
- 2
- Downloads
- 58
- Makes
- 1
- Views
- 366
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
There are many filament thru-ports for the classic Lack 3d printer enclosure, but this one is mine.
When I built my Lack enclosure, I cut up the top of my enclosure to make space for the MMU2, but never actually installed the MMU2. Because of this, I just need my filament port to go through the thin top layer of the table top. That's what my design does.
This design supports 1.75mm filament, and you'll need a short length of PTFE tubing to complete the design. Cut a 22mm length of PTFE tubing and insert it firmly but carefully so that about 1mm sticks out on either end. I have found this minimizes friction and noise.
Design notes
- This filament port is designed to go through a 1/4" hole, which was as small as I could get it to work. This does mean the bolt is somewhat delicate, so do *not* overtighten as this will almost certainly snap the bolt portion off.
- Tolerances are very small, so I recommend using a 0.4mm nozzle with 0.1mm layer height. I recommend printing at a relatively slow speed.
- If you heat your enclosure, make sure the parts are printed in a material that will hold up to the temperatures. Since this part will be located at the very top of the enclosure, it is subject to the highest temperatures.
- If this doesn't fit your brand of PTFE tubing, try scaling up or down in 1% increments.
- The port may seem to be longer than necessary at first glance. I found that the friction provided by a long bolt grips the PTFE tube well enough that it will stay in place without any additional glue.
Good luck, and I'd love to see your prints!