SLA Printer Z axis limiter bar offset
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small spacer that offsets the bar that trips the Z limiter sensor by 3mm. Fixes homing issue: plate crashing into screen
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 190
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution
After purchasing the KOYOFEI magnetic build plate (see picture) for my Anycubic Mono X 6K printer, I started running into an issue with homing the machine, where the build plate crashes into the screen before the Z limit switch is tripped, resulting in a grinding noise and an inability to zero the Z axis.
Product Link: https://www.amazon.com/gp/product/B09KXYRGX9/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1
The issue was that the thickness of the magnetic surface and the new build plate were too thick for the Z limit switch to get tripped.
This is a small printable offset that you can use to compensate for the thickness of the magnetic surface and the new build plate (3mm).
To install it (on the Anycubic Mono X 6K), you will need slightly longer hardware (M3 x 8mm).
1. Print the piece (I used one of my FDM printers/4 min print)
2. Remove the black plate that trips the Z limit switch from the printer
3. Reinstall using M3 x 8mm hardware: thread the new screws through the black plate and the spacer.
Note: the holes are offset to one side, so make sure to orient it correctly (flush with the edge and holes lining up)