Cistern aerator
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Connector to install in a cistern and allow for recirculation/aeration of water
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 303
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
I put a 330gal IBC tote (or maybe 275, I can't remember) for water storage at my property. Of course, I did not want it to get stagnant. I put a pump in for moving the water, and then just made a valve setup so when I'm not there, the pump will run on a timer every few hours to cycle the water through this aerator and keep the water moving a little bit. So far it's done pretty good.
You drill a hole in the top of your cistern and put this in, then discharge of the pump goes to the top where I have a ½" barb fitting for vinyl tubing.
Made from PETG but you can do PLA if your cistern is inside like mine. Message me if you want the fusion 360 files.