1MII Underdesk Amplifier Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wanted to be able to under-desk mount my speaker amp.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 223
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My computer speakers (Klipsch Promedia 2.1) had the speaker amp burn out and was giving my some rough hums, so I purchased a 1Mii amplifier off of amazon (https://smile.amazon.com/gp/product/B096V4KFGH/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1). The powered sub portion of the Klipsch electronics still worked fine, so I left that plugged into my pc, but I wanted some where to mount the new amplifier.
I designed this to fit around/beneath the sit/stand desk buttons I have (see image) but found it also worked under the Klipsch remote mount that I had put in, so after printing, I mounted there instead.
Print Settings
Printer:
Qidi Tech 1
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
20%
Filament:
eSun PLABlack
Notes:
Printed with normal settings. Nothing special needed on this one. Designed it to print without supports.
Left 2mm buffer spacing vertically (42mm for 40mm amplifier height) and 2mm buffer spacing horizantally (102mm for 100 mm amp width). Could scale down 1-2% for tighter fit if you like.Post-Printing
Mount
Move around on your under desk to determine where you would like it; mark screws and predrill at your choice.
I used double sided adhesive tape on top of the amplifier to keep amplifier from moving forward/backward.
Category: Music