LED strip diffuser - 10mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
120 mm long LED strip diffuser for 10 mm LED strips.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 299
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed some additional light for my scanning setup and I had these 10mm Sylvania light strips (probably purchased from Costco) on my parts shelf. Not only were they too harsh, even when dimmed, to provide the light I needed, the self-adhesive back wasn't.
I tried a few different filament colors - clear PLA, two different white PLA's, and a glow in the dark PLA. Ultimately I decided on the glow in the dark because I just like glow in dark stuff. I printed them on the non-textured side of a PEI magnetic plate on my S1Pro. I tried both lines and concentric bottom layers and found I liked the diffusion from the lines better.
There are four tabs with countersunk holes for screws. I think they're stiff enough for a single screw to hold them in place, but I believe oversized covers everything.