LED strip diffuser - 10mm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
120 mm long LED strip diffuser for 10 mm LED strips.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 19
- Makes
- 0
- Views
- 299
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed some additional light for my scanning setup and I had these 10mm Sylvania light strips (probably purchased from Costco) on my parts shelf. Not only were they too harsh, even when dimmed, to provide the light I needed, the self-adhesive back wasn't.
I tried a few different filament colors - clear PLA, two different white PLA's, and a glow in the dark PLA. Ultimately I decided on the glow in the dark because I just like glow in dark stuff. I printed them on the non-textured side of a PEI magnetic plate on my S1Pro. I tried both lines and concentric bottom layers and found I liked the diffusion from the lines better.
There are four tabs with countersunk holes for screws. I think they're stiff enough for a single screw to hold them in place, but I believe oversized covers everything.