IKEA table corner lip stoppers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount to the corners of your lack - or any other - table to add a 1mm lip
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 142
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Mount to the corners of your lack table to add a 10mm lip to your table on its corners.
Extends 20mm in either direction. Mounts either with 1 x ~#8 fastener and/or superglue.
My use was to stop a homemade cardboard enclosure from sliding off table.
I printed in PETG but i imagine PLA would work just as well if you weren't holding too much back with it.
__________
Use 4 x back for normal use. It is essentially the “standard” version.
Use 2 x back and 1 x of the other two models if you need to allow clearance on the front side, i.e. for a door swinging out. The front panel of my cardboard enclosure does this, so that's why I made the 2 other models.
__________
Let me know if you want the .f3d files and i can upload :)