1 / 12
Tapo C100/C110/TC60 Camera Thin Case & Mounting Solution
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Thin, barebones replacement case for the Tapo C-series of IP Cameras. Provides screw and/or magnet based mounting.
- Ocena
- 5 / 5
- Polubienia
- 51
- Pobrania
- 203
- Wydruki
- 0
- Wyświetlenia
- 2179
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (11)Wydruki i komentarze (Wydruki: 0) (Komentarze: 6)Remiksy (1)Kolekcje (64)Powiązane
Really liked the looks of capze's design, but needed a way to securely and universally mount the camera to any current and future projects, and felt like it could be even thinner. The original STL was hard to make precise changes too, so I re-created it in Onshape. Embraced a barebones style of look for the cover.
Assembly (Refer to last 4 images):
- Remove PCB by prying open the glossy black plastic.
- Remove Speaker wires
- Insert PCB by aligning the barrel jack closest to the rectangular indent. It should be firmly held by friction.
- Install inserts and cover
- 4x 6mm M2 Screws
- 4x M2x3 (OD 3) Heat Set Inserts
Mounting Options:
- Via two 4.8mm diameter, 3.4mm deep holes. Spaced 20mm apart and sized for M3x3 (OD 5) inserts.
- Embedded 10x2mm magnet. Add a pause at height 2.6mm. You can also use the included STEP file to cut out appropriate sized holes for whatever magnets you have.
Other Notes:
- There is a square indent and rectangular hole near the barrel jack to solder wires directly to the PCB.
- PCB Supports 1 & 2 are not identical. You will need to print both.
- There are two known versions of the PCB. Please refer to the images and print the corresponding cover. Everything else should be the same.