Insta360 X3 Case with Windstopper and Lensguard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An easy and stable case for the Insta360 X3 camera. It works with OEM wind stoppers and OEM lens guards
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 56
- Wydruki
- 0
- Wyświetlenia
- 696
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
Easy to print and use Insta360 X3 camera case.
I use the camera mainly with the lens guards and the wind stoppers attached.
Storing it is a pain since the velcro makes using the original rubber cover hard to attach.
In this case, it becomes bulkier but also well-protected. It saves a lot of time - and handling becomes way easier.
Depending on your printer, settings, and filament you might need to grind down the diameter of the 4 pins a little to make them snug in the holes.
You have to have some padding for the case.
I used 3mm grey rubber for the bottom and the white stuff (see picture) for the other areas.
My settings in Bambu Studio:
0.4mm nozzle
0.2 height
0.42 width
1st layer 50mm/s
Other layers 200mm/S
2 walls
2 top layers
2 bottom layers
15% infill
Arachne wall calculation
FilamentPM Pearl Green
215°C filament
60°C for the bed
~80g
Measurements of final box:
70x56x123mm
Print time is around 2 hours.
Stickers are not printed ;)
Enjoy!