Insta360 X3 Case with Windstopper and Lensguard
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An easy and stable case for the Insta360 X3 camera. It works with OEM wind stoppers and OEM lens guards
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 56
- Makes
- 0
- Views
- 698
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial
Easy to print and use Insta360 X3 camera case.
I use the camera mainly with the lens guards and the wind stoppers attached.
Storing it is a pain since the velcro makes using the original rubber cover hard to attach.
In this case, it becomes bulkier but also well-protected. It saves a lot of time - and handling becomes way easier.
Depending on your printer, settings, and filament you might need to grind down the diameter of the 4 pins a little to make them snug in the holes.
You have to have some padding for the case.
I used 3mm grey rubber for the bottom and the white stuff (see picture) for the other areas.
My settings in Bambu Studio:
0.4mm nozzle
0.2 height
0.42 width
1st layer 50mm/s
Other layers 200mm/S
2 walls
2 top layers
2 bottom layers
15% infill
Arachne wall calculation
FilamentPM Pearl Green
215°C filament
60°C for the bed
~80g
Measurements of final box:
70x56x123mm
Print time is around 2 hours.
Stickers are not printed ;)
Enjoy!