1 / 4
ADXL345 alternate Y-axis & PCB mount Ender 3 v3 SE/KE — zdjęcie 1
1 / 4

ADXL345 alternate Y-axis & PCB mount Ender 3 v3 SE/KE

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I didn't like the previous location all that much so I moved it, incidentally your printhead will now have horns!

Ocena
5 / 5
Polubienia
105
Pobrania
534
Wydruki
10
Wyświetlenia
6802
Oceny
8

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I didn't have any screws lying around for the printhead mount so I moved it to a place where I could reuse the screws. 

Also changed the ADXL clasp so that it can accommodate a bare ADXL345 board with soldered on pin headers.

I printed both in PLA 0.2mm layer height and without supports.

ADXL345

These boards can be directly attached and used for input shaping using the bottom USB-C port with the following pinout:

ADXL345USB-C
VCCVCC
GNDGND
D-SDA
D+SDO
CCSCL
SBUCS

The port is symmetrical so using just the A or the B side or both will work! 

Note: Before you start chopping up one of your USB-C cables, most charging cables work with only 4 or 5 cores. If you don't want to sacrifice a Thunderbolt cable it's best to use a breakout board along with a piece of network cable. 

Tagi