ADXL345 alternate Y-axis & PCB mount Ender 3 v3 SE/KE
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I didn't like the previous location all that much so I moved it, incidentally your printhead will now have horns!
- Rating
- 5 / 5
- Likes
- 105
- Downloads
- 534
- Makes
- 10
- Views
- 6,807
- Reviews
- 8
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I didn't have any screws lying around for the printhead mount so I moved it to a place where I could reuse the screws.
Also changed the ADXL clasp so that it can accommodate a bare ADXL345 board with soldered on pin headers.
I printed both in PLA 0.2mm layer height and without supports.
ADXL345
These boards can be directly attached and used for input shaping using the bottom USB-C port with the following pinout:
| ADXL345 | USB-C |
| VCC | VCC |
| GND | GND |
| D- | SDA |
| D+ | SDO |
| CC | SCL |
| SBU | CS |
The port is symmetrical so using just the A or the B side or both will work!
Note: Before you start chopping up one of your USB-C cables, most charging cables work with only 4 or 5 cores. If you don't want to sacrifice a Thunderbolt cable it's best to use a breakout board along with a piece of network cable.