HG Z'Gok leg repair
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The lower leg ball joint connector on my HG Chars Z'GOK snapped so I designed a prosthetic to fit over the residual limb
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 399
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Action Figures & Statues
- Licencja
- Creative Commons — Attribution
The lower leg ball joint connector on my HG Chars Z'GOK snapped leaving a 3.8mm long peg, so I designed a prosthetic to fit over the “residual limb”
The fit was good, but just in case I added a drop of superglue before joining.
The Settings I used are as follows:
- Sicer: Cura
- Resolution: Super Fine (.12)
- Supports: yes
- Adhesion: raft
Because it is so tiny, I had a tough time with adhesion so I restored to using a raft.
I printed 3 at the same time and tested different orientations
- Vertical with ball joint at the top
- Vertical with ball joint at the bottom
- Horizontal
I was happiest with Vertical with ball joint at the top because the ball came out the roundest but YMMV
I hope this helps :)