HG Z'Gok leg repair
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The lower leg ball joint connector on my HG Chars Z'GOK snapped so I designed a prosthetic to fit over the residual limb
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 23
- Makes
- 0
- Views
- 399
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Action Figures & Statues
- License
- Creative Commons — Attribution
The lower leg ball joint connector on my HG Chars Z'GOK snapped leaving a 3.8mm long peg, so I designed a prosthetic to fit over the “residual limb”
The fit was good, but just in case I added a drop of superglue before joining.
The Settings I used are as follows:
- Sicer: Cura
- Resolution: Super Fine (.12)
- Supports: yes
- Adhesion: raft
Because it is so tiny, I had a tough time with adhesion so I restored to using a raft.
I printed 3 at the same time and tested different orientations
- Vertical with ball joint at the top
- Vertical with ball joint at the bottom
- Horizontal
I was happiest with Vertical with ball joint at the top because the ball came out the roundest but YMMV
I hope this helps :)